Pool Resurfacing in South Florida: Signs It Is Time and What Affects the Cost
How to tell when a pool needs resurfacing, what the work includes, and the factors that decide pool resurfacing cost in Palm Beach and Broward County.
A pool finish does two jobs: it makes the shell watertight and it gives the pool its color and feel. When the finish wears out, the pool tells you. These are the signs we look for during a free estimate visit.
What to look for
- A rough surface that scrapes feet and snags swimsuits.
- Stains or discoloration that brushing and balanced water do not remove.
- Patches where the finish has worn thin and the darker layer underneath shows.
- Chalky residue on your hand when you rub the wall.
- Hairline cracks or small areas where the finish is lifting.
What resurfacing involves
The pool is drained, the old finish is prepared or removed, and a new interior finish is applied. It is also the natural moment to replace waterline tile and coping, because the pool is already empty and the edges are exposed.
Resurface or remodel?
If the shape, steps and deck still work for you, resurfacing is enough. If you want a sun shelf, a bench, new coping or a new deck, that is a remodel, and it is more efficient to do it in the same project than to drain the pool twice.
What affects pool resurfacing cost
- The size of the pool. Price follows the surface area of the walls and floor, plus steps, benches and any attached spa.
- The finish you choose. Plaster is the entry level, quartz sits in the middle, and pebble finishes are at the top.
- The condition of the old surface. Hollow spots, delamination and cracks have to be repaired before a new finish goes on.
- Waterline tile and coping. Replacing them in the same project adds cost, but far less than doing it later.
- Access and draining. Tight side yards and high groundwater take more preparation.
Why resurfacing should not be postponed
A worn finish is more than a cosmetic problem. Once the surface is rough and porous, it holds algae, uses more chemicals and stains faster. Left long enough, water reaches the shell behind the finish, and the repair grows from a new surface to structural patching.
Resurfacing while the shell is still sound keeps the project simple and the price predictable.
Choosing a pool resurfacing contractor
- Confirm a Florida pool contractor license. Ours is CPC1460998.
- Ask how the old surface will be prepared, and get it in the written scope.
- Ask to see finished pools in the same finish you are considering.
- Make sure start-up and water balancing after the fill are included.
Frequently asked questions
Do you have to drain the pool to resurface it?
Yes. The pool is drained so the old surface can be prepared and the new finish applied. It is refilled immediately after the finish is complete.
Can I change the color of my pool when resurfacing?
Yes. Resurfacing is when the color changes. Light finishes give pale blue water, and grey or dark finishes give a deeper blue.
Should I replace the waterline tile at the same time?
If the tile is dated, loose or stained, this is the right moment. The pool is already empty and the new finish is applied up to the new tile for a clean edge.
How do I get a price for my project?
Call (561) 652-0105 or send the form. We visit the property, measure, and send written pricing with a 3D projection of the finished project. The estimate is free.
Where we work
Forben Construction serves Palm Beach and Broward County, including Fort Lauderdale, Pompano Beach, Deerfield Beach, Coral Springs, Parkland, Boca Raton, Delray Beach, Boynton Beach, West Palm Beach, Palm Beach Gardens and Jupiter. See our Pool Remodeling service or request a free estimate.
See our Pool Remodeling service →


